Regency F33-1 Freestanding Gas Stove
7
INSTALLATION
Pedestal & Leg/Bottom Shield
Wiring Instructions
1)
Disconnect the fan harness plug.
2)
Disconnect the 240V power cord from the terminal block
3)
Disconnect the three wires from the 3-way fan switch.
4)
Install the 3-way fan switch into the Bottom Shield or
Pedestal. Note: remove dummy switch first.
5)
Install the power cord through the small hole in the rear of the
Bottom Shield or Pedestal
6)
Re-connect the power cord to the terminal block.
7)
Ground the power cord and mount the terminal block if
required.
8)
Re-connect the 3 wires back to the 3-way fan switch (the
white wire is the middle connection).
9)
Connect the yellow wire from the gas valve to the Burner
2-way switch supplied with the Bottom Shield or Pedestal.
10)
Connect the orange wire from the spill switch to the
Burner ON/OFF switch.
11)
Re-connect the fan harness plug.
12)
Secure the power cord with the supplied grommet at the
back of the Bottom Shield or Pedestal.
Wiring Diagram on page 8.
LEG AND BOTTOM SHIELD
ASSEMBLY
These instructions apply to the steel leg, painted cast leg and the
gold plated cast leg. It will be easier to attach the legs to the stove
if it is tipped on its back (preferably on a soft surface to prevent
scratching).
1)
Remove the 4 bolts in the underside of the base and
discard.
2)
Put the bottom shield up against the bottom of the stove and
loosely install the four supplied bolts and washers into the
threaded holes in the four corners of the bottom the unit.
Once the bolts are started, slip the leg under the washer and
tighten the bolts.
3)
Hook up wires to Burner ON/OFF switch and valve as-
sembly as per wiring instructions above. See Diagram 1.
4)
Level the stove by adjusting the levelling bolts in the bottom
of each leg.
