Version 10/21
Page 33 of 49
PAWS UM EN
•
Adjust the centres of the Clamp Jaws to align with the centres of the Wheelchair front tubes by moving
the Clamp Assembly in or out of the Width Adjustment Assembly.
•
Adjust the Jaw opening, using the spanner provided, to easily receive the front tube of the Wheelchair.
Do this for both sides.
•
Once the centres of the Clamp Jaws are in line with the mid-line of the Wheelchair tubes, roll
the Wheelchair forward so that the front tubes are inside the Clamp Jaws.
Attention!
The tension on this lever can be adjusted using the nut on the other side of the lever. See Figure 12
above.
Figure 30. Adjusting the Clamp Jaw width
Figure 31. Roll the Wheelchair to the Device
Handy Tip:
Adjust the Width Setting Ring Bolt D on the lower rod of the Clamp Receiver
–
fix this in place to mark the
width and make it easy to reposition if the Clamp Mechanism needs to be removed for transport. All other adjustment
settings will be retained.
Attention!
The recommended Torque setting of Bolt D is 5 Nm (Newton Meters).
•
Set the lateral angle of the Clamp Jaws to the front tubes by rotating Bolt A.
•
The Clamp Jaws should grip the Wheelchair tubes evenly when they are closed. Do this for both sides.
Attention!
The recommended Torque setting of Bolt A is 50 Nm (Newton Meters).
D
