Version 10/21
Page 35 of 49
PAWS UM EN
•
Then press the Device Power Button for three seconds to power up the Device.
•
Close the Jaws by pressing the Auto Lift Clamp Switch to the right side
–
indicating jaws closed
–
until
the jaws have closed. Then immediately return to the middle or neutral position on the switch so as not
to go to the lifting position.
Attention!
If the Auto Lift/Clamp switch stays pressed on the right-hand position for more than seven seconds, it
will start to lift the Wheelchair. At this stage of adjustment, do not allow lifting until all adjusting bolts and levers are
tightened and closed.
•
Check all adjusted angles, widths, and depths to ensure a symmetrical fit, and then tighten all nuts and
bolts to the recommended settings.
Attention!
The recommended Torque setting of this angle and depth adjustment Bolt B is 25 Nm (Newton Meters).
See Figure 34 above.
The Device is now ready to operate.
14.
Operating
Description
This section describes the processes for starting up, operating, and shutting down the Device with the Wheelchair.
Battery
•
Ensure the Battery is fully charged before a period of extended use.
•
Fully charge the Battery after every use
–
this will extend battery life.
•
Remover the dust cover from the Battery Socket and insert the Charger Cable Plug to the socket.
•
Observe the colored LEDs on the top of the Battery
–
red indicates lowest charge range (25% or less);
three green bars indicate highest battery range (75% to 100%)
•
When charging, the level of charge will be indicated by a flashing LED Bar. When fully charged, the
LED will be constant.
•
For more detail on the Battery and Charger please see “Appendix 1: Battery and Charger”.
Clamping and Lifting
•
Make sure the Device is supported by the Supporting Legs.
•
Roll the Wheelchair into the Device so that the leg tubes are inside the clamp jaws.
•
Insert and Power up the Battery and turn on the Power button on the Handlebars.
To Clamp
•
If Manual, close the jaws by pulling on the Clamp Lever.
•
If Auto, press the Device Power Button to turn on the Device.
•
Press the Auto Clamp/Lift Switch to the right to close the Clamp Jaws.
