Version 10/21
Page 44 of 49
PAWS UM EN
Note: In the below situations, the Battery will enter Sleep Mode after 30 minutes. Press the button briefly to
reactivate.
•
Output current less than 1A
•
Disconnected with controller signal
•
Charging current less than 100mA
Charging the Battery Pack
•
The Battery can be charged while in the device or separately.
Removing the Battery to charge is recommended.
•
Connect charging plug to Battery pack
•
Remove the rubber cover from the Charger Socket
•
Align the slot with the marker and insert the Charging Plug into the Charger Socket,
•
After charging, disconnect the Charging Plug from the Charger Socket,
•
Replace the rubber cover on the Charger Socket.
Figure 43. Battery Charging Connection
Attention!
Handling and storing the Battery
•
Do not use Batteries or cells not approved by the manufacturer!
•
Please read the Battery handling instructions carefully before use. Improper use of the Battery may
cause over-heating, rupture, damage or fire.
•
Do not expose the Battery to fire or heat; do not store the Battery at higher temperature that
specified is this User Manual.
•
Do not connect the Battery, Charger or other equipment with reversed positive (+) and negative (-)
terminals.
•
Do not connect the Battery terminals (+ and -) with any wire or metal (like metal necklaces or
hairpins). Otherwise, short-circuit may occur during carrying or storage.
•
Protect the Battery against physical damage at all times.
•
Do not disassemble or alter the Battery
’s
outside structure in any way.
•
Do not expose the Battery to wet conditions or immerse it in water
.
•
Performance and safety are only ensured with use of the original Charger, in compliance with
correct operating procedure, at a voltage and temperature within the specified ranges.
