Version 10/21
Page 5 of 49
PAWS UM EN
•
The Device is not recommended for use on sand, mud or in extreme weather conditions unless
indicated in the model’s
approved use environments.
•
The temperature range for use is between -25 degrees Celsius and 50 degrees Celsius.
•
The Device should not be exposed to strong electrical fields, excessive heat, or moisture.
•
The D
evice’ s operation might interfere with other electrical devices.
•
Do not under any circumstances exceed the technical limits stated in this User Manual.
Driving training, obstacles, and slopes
•
We recommend driving training for all new Users of the PAWS, to ensure familiarity with the Device and
its limitations.
•
The Device can climb obstacles with a maximum height of 5cm
–
do not exceed this obstacle height.
•
On inclines, it may be necessary to lean forward to move the center of mass (or gravity) closer to the
drive wheel to maintain traction of the drive wheel.
•
When the Device is attached to the Wheelchair, it is regarded as a three-wheeled vehicle. Reduce speed
when turning or navigating kerbs, cambers, and bumps to avoid tipping over.
•
Always be mindful of your speed when driving on public roads or footpaths. Please observe and follow
the local road traffic regulations in the country of use.
•
Practice driving on level ground before attempting sloped surfaces to become familiar with the Device
and its limitations.
•
When driving and after releasing the throttle, please be aware that the Device will not stop
automatically. The handbrakes must be applied to bring the Device to a full stop.
•
Unless the brakes are applied, there is risk of the device moving on a sloped surface. Always apply the
brakes when not using the throttle.
•
Do not climb slopes (up to 10 degrees) in “Walk mode” only. We recommend the lowest speed mode
(Mode 1) for climbing.
•
Ensure your Battery is fully charged before attempting trips over sloping ground.
Usage and Speed
•
Always drive within your ability to control the Device and stop safely. Using/driving the Device at
controllable speeds is the U
ser’s responsibility and the
Manufacturer/Distributor will refuse
responsibility for accidents or damages to third parties.
•
Speed limits are determined according to local traffic regulations. These limits are programmed at the
time of manufacture and are adjusted using tiered 1 to 5 settings. Further reduction of speed limits
based on user requirements can be programmed by the Distributor.
Attention!
•
The Device must not be loaded with more than 120kg.
•
Use the Device only in suitable conditions and only for its intended purpose.