05/2020
Strona 16 z 23
Icon 60 Vario S
Watch out for your fingers during assembly and disassembly wheels. Do not put them between the spokes or
between the wheels and the push rims.
Watch out for spokes when driving. Spoke covers (accessory) are recommended to secure your fingers.
Rear wheel balance adjustment
•
To change the position of the rear wheel,
unscrew the wheel bushings (1) from the
hole in the black mounting plate and move
the bushes together with the rear axle to
another available hole in the rear axle
bracket, maintaining the correct order of
the washers and nuts.
•
If a wider adjustment range is needed,
loosen the 4 screws (2) on both sides of
the wheelchair, that hold the black
mounting bracket to the frame bracket,
move the vertical support forward or
backward to the desired position, and then
insert and tighten the 4 screws in the new
position while holding the nuts on the
bottom / inner side of the wheelchair.
14.2 GENERAL
14.2.1. Front wheels
Front wheel adjustment
When the position or size of the rear or front wheels is
modified, it may be necessary to adjust the angle of the front
wheel fork to avoid "fluttering wheels" and ensure a smooth,
straight ride.
The head of the front fork assembly (1) should always be
placed at an angle of 90
°
to the ground. After changing the
wheel setting, this angle must be set.
To adjust the angle of the front fork:
• Loosen 1x screw (1)
• Loosen 2x screws (2), adjust (3) front fork assembly until the
vertical axis of the bearing (1) is at an angle 90
°
to the ground
• Tighten the screws again (1) i (2), check the angle with the
ground again.
• Do the operation symmetrically on both sides of the
wheelchair.
3
1
2
90
°
2
2
1
2
