OPERATOR’S MANUAL ULTRA GUIDANCE PSR ISO
PAGE 45
CHAPTER
OPERATION
The following speed sensors are available for selection:
GPS:
Speed signal from GPS receiver.
ISO GBSD:
ISO BUS 11783 message. Ground Based
Speed. This speed is measured on the ground. The
speed could be detected by radar sensor, for example.
ISO WBSD:
ISO BUS 11783 message. Wheel Based
Speed. This speed corresponds to the speed at wheel
including slip.
Incremental sensor:
Speed pulses from the vehicle/ra-
dar sensor.
If the current speed is being detected by the GPS receiver
or ISO bus 11783, the menu will switch directly to the
selection menu for the speed signals.
Using an incremental sensor
Choose
and confirm the selection.
Press and hold the function key
until the stored symbol
appears. Proceed as described in chapter 4.12.
After confirming the selection, the following menus are available
for selection:
Speed sensor type:
Selection of speed sensors.
Incremental:
For setting the speed pulses manually.
Auto:
For setting the speed pulses automatically.
Picture 60:
Setting the incremental sensor
