OPERATOR’S MANUAL ULTRA GUIDANCE PSR ISO
PAGE 81
CHAPTER
PSR SKY
5.7.
Set working width
The working width is required to assure a correct distance paral-
lel the reference line.
Choose
and confirm the selection.
For
or
, proceed as described in the associated
chapters.
Advice!
This function is only available as long as the
automatic steering is deactivated.
Advice!
When setting the working width consider a few
inch overlap to avoid gaps.
This overlap depends on the quality of the GPS signal.
It ranges from 1 to 4 inches with (RTK signal) or 6 to
12 inches with a (DGPS signal). It is best to determine
the overlap on location with a test run.
Set the working width with the function keys
,
.
Alternatively, you can also set the value manually as described
in chapter 4.11. Working widths between 1,64 ft to 164 ft are
possible.
Press and hold the function key
until the stored symbol
appears. Proceed as described in chapter 4.12.
Advice!
Should the GPS signal weaken during a particular
field operation, the working width may need re-setting.
This causes all passes to be moved with the new setting.
In this case it is necessary to recalibrate the system
to the reference line after each change to the working
width (see chapter 5.5.1.).
Picture 135:
Select setting of working width
Picture 136:
Set working width
