10
Model 787: Setting of the depth stop with contact switch
Move the trigger mode switch (3) to position 2
Tip the machine on to its left side
Loosen the clamping screw (15)
Move the complete depth-stop
assembly (16) to the required
dimension on scale (17)
(scale value = distance from
upper margin to bottom edge
of impression in millimetres)
Be careful: Danger of
squeezing the fingers!
The depth-stop (16)
may be hot.
When adjusting, take care that the
depth-stop unit does not jam in its
guide. Touching the depth-stop unit
near its guide axis (18) helps to
prevent jamming.
Retighten the clamping screw (15)
Set the desired kind of triggering (see page 9)
Switching off the depth stop with contact switch
Push the yellow slide (9, figure on page 9) to scale value 95
Turn the red setting wheel (10) in the opposite direction
of the arrow (figure on page 9) to position 0.
Turn the trigger mode switch (3) to the desired kind of triggering
With Model 787, the depth stop cannot be switched off
17
15
16
18
i
Note
!
Caution