27
Press the
[ set ]
button: The print head moves to its
right-hand limit
Lift up the housing cover and remove it
Set the trigger mode switch (3) to position 2
First pull the left-hand end of the foil mask (20) forwards off the
frame (tension in the mask is released)
Pull the foil mask forwards off the right-hand side of the frame
and discard it
Fit the new foil mask with the arrow marks (13) and (14)
to the front (see figure on Page 12). First push it on to the
right-hand side of the frame until it reaches the stop.
Tension it slightly and push it on to the left-hand side of the
frame until it reaches the stop
Reset the trigger mode switch (3) to the required position
Refit the housing cover
Changing the ink - ribbon protection mask
13
14
3