ENGLISH
______________________________________________________________________________________________
_____________________________________________________________________
C.A.P.T. S.r.l. con Unico Socio
Soggetta a direzione e coord. di
Maschinenfabrik Reinhausen GMBH
Via Postale Vecchia 17
36070 Trissino (VI), Italia
Phone:. +39(0)445/962297
Fax: +39(0)445/490606
http://www.capt.it
E-mail:
PEC :
capt@legalmail.it
REINHAUSEN
GROUP
MAN-099-EN - rev.02 EN
5
• Assembling though specific holes by metallic and/or insulating (*) material.
Standard appliances and devices are performed in the catalogue.
On cable operated tap changers type 099, the electrical part is separated from the mechanical
control. The electrical part is composed by two insulated Bakelite plates that contain the fixed
contacts; in the middle, there is the moving Bakelite strip carrying the moving contacts that slides
parallel to the plates, operated by the steel cables. The cables curvature should not be excessive.
The minimum radius must be at least 140 mm.
2.3
Drive handle.
The operating device consists of a drum fixed to the operating handle; steel cables wound around
it. On drum casing, there are two (or four) setting screws that permit the position adjusting of
moving strip and eliminate any transmission clearance. Each position is marked by a specific notch
that block the tap changer in the correct position.
To change position it is necessary to lift axially the knob, turn the knob and insert it in the new
position. The action of a spring facilitates this last operation.
2.4
Technical features
NUMBER OF POSITIONS:
Standard from 3 to 7 positions.
VOLTAGES
Voltage classes 24 kV and 36 kV
CURRENTS:
30 A
–
60 A
–
150 A
–
200 A.
3.
SHIPMENT
3.1
Shipment
The material is shipped with the right and proper packaging suitable for the type of shipping.
Inside the box, divided from tap-changers, there is the sheath provided in skeins. Each tap-
changer is closed in a plastic bag with the complete kit for drive handle.
