OPERATING INSTRUCTIONS
Congratulations on your purchase of the Rejuvenate
®
Fabric Renewer Pill & Fuzz
Shaver—the easiest way to remove fuzz balls, pills, lint, and pet hair. The triple
action blades remove tough pills with ease! Please read all instructions and
warnings in this manual prior to using your Fabric Shaver.
Using the Fabric Shaver
• Plug the A/C Power Adapter
into the Adapter Input
A
or use the fabric shaver with batteries
(see battery use on page 4).
• Turn the fabric shaver on by using the
one touch sliding ON/OFF switch
B
Place fabric you wish to renew on a flat surface. Holding the device by its handle,
gently glide it over the fabric. Pull the fabric as straight as possible to increase the
efficiency and results of the device.
Useful Tips:
• Tuck in exposed threads before
shaving to prevent damage.
• Test the fabric shaver on a hidden or
inconspicuous area before using it on
the entire fabric surface.
• Do not press the device too hard against the fabric as it may cause damage.
• After each use, or when Storage Box is half full, pull out the Storage Box and
dispose of the fabric shavings inside.
• If efficiency of the device becomes low, open the Screen Cover by
unscrewing it counter-clockwise. Carefully take out the cutting blade,
then clean the blade and inner compartment with the soft brush included.
Replace Screen Cover.
Warning: Unplug the shaver prior to opening the Screen Cover;
blades are sharp so please use caution.
•
The device is equipped with a safety switch that will disable operation when
the Screen Cover is loose or opened.
3
A
B
