Assembly instructions
Instructions d’assemblage
Instrucciones de Ensamblaje
2019-11-20
www.rejuvenation.com
6/14
POSITION THE VANITY BASE
Position the vanity base in the desired location against the finished wall. Remove baseboard
as needed.
Verify that the vanity base is level: front to back and side to side. Adjust the levelers at the
bottom of the legs as necessary.
ATTACH THE VANITY BASE TO THE WALL
Locate two wall studs to secure the vanity base. Make sure to avoid plumbing.
Drill pilot holes through the back and into the studs. If necessary, provide shims between
vanity and back rail so the vanity base is not distorted.
Using screws (not supplied), secure the vanity base to the wall.
Do not use wall anchors.