1
CN2
2010
INSTALLATION INSTRUCTIONS FOR THE TIME AND
TEMPERATURE CONTROL with REMOTE CONTROL
MODELS JR-1, JR-2, JR-3, JR-4
Before commencing with these instructions, ensure that the RELAX-A-MIST
TM
steam generator has been installed according
to the steam generator installation instructions.
1. GENERAL INFORMATION
The RELAX-A-MIST
TM
time and temperature control is a
simple programmable control. The user friendly design
has programmable time and temperature settings. Once
a program is set and running, you may temporarily over
ride the settings by pressing the time or temperature
buttons and pushing the applicable increment arrow.
Upon completion of the timed setting, or halting your
steam bath with the “on/off” button, your temporary over
ride setting will return to the programmed default settings.
Your steam bath is ready for your next use. Power supply
interruptions will not change or delete your default time
and temperature settings.
The digital time and temperature control comes as a
package complete with the following:
1. One programmable time and temperature control.
2.
One remote control.
3.
One 25 foot cord set (steam generator connection
wire to control) with a modular male plug-in at the
steam unit and a modular female plug-in at the control
in the steam shower or steam room.
The programmable time and temperature control must be
located inside the steam room, approximately 4 feet off
the finished floor and NOT in an area above the steam
nozzles. The thermostat sensor is built into the bottom of
the control. The remote control can only operate the main
control from a direct line of site.
NOTE: Inside of the steam room, the six inch wire on the
back of the Time & Temperature control (with the male
plug), connects into the 25 foot wire (with the female plug).
At the steam generator, the male plug from the 25 foot
wire connects to the female plug located on the side of the
steam generator’s electrical box marked “Timer Switch
and 24 VAC”. The cord set modular female connection
must be identified at the steam generator (do not plug the
switch cord into the automatic drain connection). The
control’s 25 foot cord set wire must be installed during the
rough in, with the male end at the steam generator and
the female end at the area in the steam bath where the
control will be installed on the wall.
2. ROUGH IN
ELECTRICAL
(According to local electrical code)
Check to ensure that the Relax-A-Mist
TM
steam
generator has been installed according
LR42682
to the steam generator installation instructions.
Install only the
RELAX-A-MIST
TM
25 foot cord set wire
(compatible with the Quick Touch Timer or the Time and
Temperature Control) ensuring that the modular male plug
is located in the area where the steam generator is to be
installed. The modular female connector of the 25 foot
wire should protrude out of the wall about 6 inches into the
shower or steam room where the control will be installed.
You will need to make the hole in the cement board and
the finished tile approx. 7/8" diameter to allow the modular
wire connectors from the control and the 25 foot cord set
to pass back inside the wall for the final installation. DO
NOT ADHERE CONTROL TO WALL UNTIL YOU HAVE
COMPLETED THE STEAM GENERATOR START UP
AND CONTROL PRETEST.
CAUTION
CAUTION
CAUTION:
DO NOT STRETCH WIRE TIGHT. DO NOT STAPLE
THE WIRE TO STUDS. CHECK ORIENTATION OF
MODULAR CONNECTORS ON CONTROL CORD SET.
NOTE:
The electrical "supply" for the steam generator
CANNOT be switched directly by the time and
temperature control
.
