User manual MR004DL/FA
07.03.02, Version 1.2
9
GmbH, Stettiner Str. 38, D-33106 Paderborn
Access by ID:
The M-Bus Display support a different setup of the passcode mode from
the menu „Display config. – Passcode mode“. If this mode is activated, the user (tenant)
can make a readout limited to his own meter(s). After first key-press the tenant is
requested to type in the ID (identification no.) of the required slave. Afterwards this
single meter is read and its data displayed. Please note that only meters which support
secondary addressing are readable in this mode. The access to the menu is additionally
possible in this mode after input of the ID 00000000 and login with the described
passcodes.
Access by Adr:
This mode allows a direct readout of meters using their primary
addresses without any login procedure. This mode is similar to “Access by ID”. The
primary address for global readout 254 is used by default. So by just pressing the E key
you can read a meter if it’s there is only one meter connected. The cursor keys allow
editing the address. You can leave the input mask and step to the passcode request by
pressing 3-times the
→
key .
4 Keyboard operation of MR004FA/MR004DL
Basics:
Besides the control using Fservice the device includes 4 keys and a backlighted display
for comfortable, local access to all functions. The buttons give a very precise,
mechanical feedback and each input is acknowledged by an acoustic signal (beep).
Execution of menu entries and input of numbers are described later. The device
automatically returns to inactive state after some minutes with no input.
Selection of a menu entry:
An arrow marks the active menu entry on the LCD. The arrow is moved down with the
↓
key and up with the
→
key. Pressing the E button executes the current, selected menu
entry. The C button cancels the input and exits from the menu.
↓
key
Input of numbers:
The
↓
button increments the number of the active position by one. After the 0 ist restarts
with the 9 again. The
→
key moves the cursor to the next position on the right. The
active position is blinking. After pressing
→
at the most right digit the cursor moves to
the most left digit. The E button ends and acknowledges the input regardless of the
current position. You can cancel the input with the C key.
After input of passcode and confirming with the E key the main
menu is activated. You can see always two entries of this
menu. The first displayed lines are “Readout of all” and “Single
↓
button the LCD scrolls to the next
part of the menu. In this example the line “Single readout” will
then be marked with the arrow. This submenu would be entered
with the E key.
