General characteristics
• Step electronic universal relay with external push button (not supplied).
• Controlled from several points with push buttons of any series even with pilot light (max. 5).
• Can be controlled by remote control (Aladino Plus series)
• Noiseless
commutation.
• Memory function even when current is cut off
• Voltage 230Vac 50Hz
Directions for use
Controlled with push buttons or infra red or radio transmitters. To switch on and off press the button.
Rules for installation and use
Connect RL UN (RELE’ PP) in series with load or sensorial touch device RIPMo34S.., SHUI series. Keep housing
away from direct sources of heat. The temperature should be 35°C, for every 5°C extra reduce power by 20%. Install
respecting CEI after having switched off mains, and following carefully connection diagrams. Use cable of adequate
size (not less than 1,5mm) and tighten terminals accurately. It is possible to control with infra red (Fig.2) or radio wave
system (Fig.3).
Every models has been carefully tested and L.C. Relco guarantees correct functioning if instal-
lation rules and rating are respected.
GB
www.relco.it
tecnico@relco.it
Fig.1 - RL UN + pulsante NA
Fig.2 - RL UN + RICE RADIO 2
Fig.3 - RL UN + RIP MO 34 S..
Fig.4 - RL UN + RICE IR 34 S..
N.B Rispettare obbligatoriamente i riferimenti di FASE e NEUTRO per il corretto funzionamento
N.B. Please respect PHASE and NEUTRAL references for correct functioning
