1-877-789-3245 | info@reliance-foundry.com | www.reliance-foundry.com
Collapsible Bollard Installation
Fold-Down
Mounting
Parts List
Installation Equipment
#
PART
QTY
1
Fold-Down Bollard
1
2
Fold-Down Base
1
3
Hexagon Socket Button Head Cap Bolt 3/8"
2
4
Hex Nut Nylon Lock 3/8"
2
5
Hexagon Socket Button Head Cap Bolt 1/2"
4
6
Stainless Steel Washer 1/2"
4
7
Drop-in Concrete Insert 1/2"
4
8
Padlock (optional)
1
5/8" Masonry Drill Bit
Hammer
1/2" Insert Setting Tool
Hammer Drill or Rotary Hammer
9/16" Wrench
Broom/Pressure Washer
5/16" Hex Key
Vacuum
7/32" Hex Key
Level
Chalk
Measuring Tape
To protect the finish, keep bollards in original
packaging until exact moment of installation.
Handle with care to avoid scratching or
damaging bollard surfaces.
Once scratched, bollards cannot be repaired
to original form without re-finishing the entire
surface.
Bollards shown in the diagrams may not be the same model as the bollards shipped in this order. This does not affect the integrity of the installation.
Before Installation
STEP 1:
Always check for hazards such as water pipes,
gas lines, and underground wiring before digging.
STEP 2:
Use a broom or pressure washer to clean the
concrete surface prior to bollard installation.
STEP 3:
Study the site plans to locate and mark the
precise center point of each bollard. For secure
installation, ensure there is a minimum radius* of solid
concrete around each mark.
* Concrete insert manufacturers such as www.ucanfast.com
recommend a radius of 9"
1
2
3
4
6
5
7
8
