18
Notes:
?
Press the [TX Power] key while using a channel programmed with low power, an error
tone will sound and the transmit power will not change.
?
When changing a channel from high/middle power to low power, all other channels
programmed with high/middle power will change to low power accordingly.
Beginning/End of Transmission ID Signal
The radio can be programmed to send Beginning/End of Transmission ID when
accessing / releasing repeaters or telephone systems. The ID signal includes DTMF and
5-Tone types. Two modes can be configured:
? Press the [PTT] key to send a Beginning of Transmission ID Signal; Release the [PTT]
key to send an End of Transmission ID Signal.
? Press [*] while holding down the [PTT] key to send a Beginning of Transmission ID
Signal; press [
#
] while holding down the [PTT] key to send an End of Transmission ID
Signal (for DTMF type only).
Channel Scan
?
Scan Types
? Single Zone Scan
All channels in the current zone that have been added to the scan list can be scanned.
? Multi Zone Scan
All channels within all the zones that have been added to the scan list can be scanned.
? List Zone Scan
The radio only scans the channels within the specified range of zones that have been
added to the scan list. Individually each zone is assigned with a scan list, which provides
quick recognition of the zones to be locked out of scan list.
Note: Scan list for each zone can be added/ deleted.
?
Scan Start
Press the key programmed as [SCN], scan starts from the current channel and ascends
through the channel numbers in scan list. “SCAN” appears on the LCD (
“
-SCAN X -
”
in
List Zone Scan mode, “X” is the current list number).
Note: Scan function can be used only when two or more channels are in the scan list.
?
Scan Stop
1.
Press the [SCN] key again to stop scanning. “SCAN” disappears on the LCD.
2.
Activate the Monitor function.
3.
Carrier is detected on channels where no signalling is set.
4.
Carrier is detected on channels where signalling is set, and the matching signalling is
received.
