EN
Adjusting the cutting height
–
Do not open the tank cap while the engine is
running or if the machine is hot.
–
Replace a damaged petrol tank and/or tank
cap.
–
Always close the tank cap.
–
If fuel overflows never attempt to start the
motor. Instead, move the machine away from
the fuel contaminated area. Avoid any
attempt to start the ignition until the fuel
vapours have evaporated.
–
If motor oil has leaked out:
–
Do not start the motor
–
Soak up the leaked motor oil using an oil
binding agent or rag and dispose of it
properly
–
Clean the unit
Used oil may not:
–
be disposed of in household waste
–
be dumped into the sewage system,
drain or onto the ground
Filling with petrol
We recommend disposing of used oil in
a closed container at a recycling centre
or a customer service centre.
Important!
You must fill up with engine oil and fuel
before you can start the engine.
1. Unscrew the fuel tank cover and store in a
clean location.
2. Fill up with petrol using a funnel (1)
3. Close the fuel tank filler opening firmly and
clean.
Filling with motor oil
1. Unscrew the oil fill cap and store in a clean
location.
2. Fill up with oil using a funnel (2).
3. Check the oil level shown on the dipstick (3).
4. Close the oil filler opening firmly and clean.
STARTUP
CAUTION!
The equipment should not be used if the
cutting unit and/or mounting components
are loose, damaged or worn.
Always make a visual inspection of the
equipment before using it.
CAUTION!
Risk of injury!
Adjust the cutting height only while
motor is switched off and the cutting
blade has stopped!
– Cutting height adjustment depends on
the model.
Central adjustment (4)
–
To unlock, press the lever to the side and
hold.
–
Slide the lever to the left or right in the desired
cutting height.
–
Allow the lever to engage.
–
Make sure all wheels engage at the same
position.
Mowing with grass catcher (6)
CAUTION!
Risk of injury!
Remove or replace the grass catcher
only while the motor is switched off
and the cutting blade has stopped.
– Lift up the baffle plate and hang the grass
catcher into the holders.
Fill level indicator
The level indicator is pressed upwards by the
air stream during mowing (5a). When the grass
catcher is full, the level indicator rests against
the catcher (5b). The grass catcher needs to be
emptied.
Emptying the grass catcher
1. Lift the baffle plate.
2. Unhook the grass catcher and remove it to
the rear (6).
3. Entity the grass catcher.
4. Lift up the baffle plate and hang the grass
cat-cher back into the holders (6).
Mowing without the grass catcher
CAUTION!
Risk of injury due to rotating parts!
Only work without the grass catcher if
the deflector plate torsion spring is
working correctly.
The deflector plate is held to the mower housing
by spring force. This causes the mowed grass
to be thrown backward and downward.
19
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com
Summary of Contents for LMEm 5602 BSB PLUS
