ECO mode operation is enabled.
Switch the appliance off then on again.
4.3.3
Browsing in the menus
Important
Depending on the devices or control PCBs connected, the
control panel shows selection options in some menus.
First, select a device, control PCB or zone to view or amend a
setting.
1. Press any key to activate the controller from the stand-by screen.
2. Access the available menu options by pressing the two keys on the
right simultaneously.
Tab.11 Possible menu choices
Information Menu
User menu
Installer Menu
Manual mode menu
Failure Menu
Hour Run Meters / Timer Program / Clock menu
PCB menu
(1) The icon is displayed only if an optional control PCB has been instal
led.
3. Press the key to move the cursor to the right.
4. Press the key to move the cursor to the left.
5. Press the
key to confirm selection of the required menu or
parameter.
6. Press the or key to modify the value.
7. Press the
key to confirm the value.
Fig.7
Step 1
MW-3000377-02
Fig.8
Step 2
MW-3000299-01
Fig.9
Step 3
MW-3000300-02
Fig.10
Step 4
MW-3000301-02
Fig.11
Step 5
MW-3000302-01
Fig.12
Step 6
MW-3000303-01
Fig.13
Step 7
MW-3000304-01
4 Description of the product
22
7665063 - v.05 - 18102018