Remington EP7 Series, Instructions Manual

7

MASSAGE CAP WITH ALOE VERA

• 

The Massage Cap is designed for gentler epilation.

1.  Ensure the epilator is switched off.

2.  Remove the Ultimate Contour or Detail Cap.

3.  Place the Massage Cap into the appropriate slots at the top of the epilator.

4.  Gently press the Detail Cap into place until you hear a “click”.

SHAVER HEAD

• 

The shaver head provides a close shave for sensitive areas.

1.  Ensure the epilator is switched off. 

2.  Press the head release button and remove the epilator head.

3.  Attach the shaver head until it clicks into place.

4.  Hold the shaver head at a 90° angle to the skin and move against the direction of 

hair growth.

TRIMMING AND SHAPING

1.  Attach the bikini comb to the shaver head.

2.  Hold the shaver at a right angle to your skin and press down gently.

3.  Edge and shape the areas as desired.

EXFOLIATING BRUSH HEAD

• 

The Exfoliating Brush spins to remove dead skin cells from the surface and helps to 

prevent ingrowing hairs.

1.  Ensure the epilator is switched off.

2.  Press the head release button and remove the Epilator Head.

3.  Attach the Exfoliating Brush Head until it clicks into place.

4.  For best results dampen the skin with water and apply shower gel or body wash.

5.  Turn the unit on to the LOW speed setting.

6.  Applying gentle pressure sweep the brush over the skin targeting the desired areas. 

If required the Exfoliating Brush can also be operated on the HIGH speed setting.

• 

Note: The Exfoliating Brush is not to be used on the face or sensitive areas.

• 

Can be used on wet or dry skin.

PEDICURE HEAD

• 

The Pedicure Head spins to gently remove hard, dry skin from the feet.

1.  Ensure the epilator is switched off.

2.  Press the head release button and remove the Epilator Head.

3.  Attach the Pedicure Head until it clicks into place.

4.  Turn the unit on to the LOW speed setting.

5.  Applying gentle pressure glide the roller over the hard skin you wish to remove. Do 

not press too hard.

6.   After 2-3 seconds, stop and check the skin. Repeat this process until you have the 

desired effect. If required the Pedicure Head can also be operated on the HIGH 

speed setting.