5
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
If the moving blade has been removed this can be re-fi tted by slotting the long grooved
edge of the blade onto the two white plastic guide ridges and then seating the blade over
the plastic actuator bar. The fi xed blade is fi tted with the raised profi le pointing outwards
and fi xed with the 2 screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and align
the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.
Note that if the blades are not correctly aligned then cutting effi ciency will be impaired.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
CAUTION: Do not use liquid cleaners on the blades or harsh or corrosive chemicals on
the blade casing. Always use a soft brush to remove the accumulated hairs.
Unplug the charge adaptor from the power outlet when fi tting or removing attachments,
or while cleaning the product.
Always store this appliance and cord in a moisture-free area.
Do not wrap the cord of the charging adaptor around the appliance.
TROUBLESHOOTING
If blades do not seem to cut hair easily, the taper lever (PICTURE 6) can be used to remove
any hair caught between the comb and blade. Switch the clipper on and move the taper lever
up and down a few times but do not force the lever in either direction. This should remove
hairs and restore the cutting effi ciency. If not, contact your nearest Remington Service
Centre.
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR
INJURY TO PERSONS:
An appliance should never be left unattended when plugged into a power outlet.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not plug or unplug the shaver with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via our
Remington
®
service center.
Charge, use and store the product at a temperature between 15°C and 35°C.
Always unplug from the mains when cleaning.
Only use the parts supplied with the appliance.
Keep this product out of reach of children. The use of this appliance by persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge can
give cause to hazards. Persons responsible for their safety should give explicit instructions
or supervise the use of the appliance.
GB
080162_REM_IFU_HC365_UK.indd 5
28.02.2008 14:00:37
