5
PARTS
1. On/off switch
2. Blade set
3. 18mm attachment guide comb
4. Charging indicator light
Not shown:
• 6-15mm attachment guide comb
• Blade release buttons
• Scissors
• Comb
• Storage case
• Cleaning brush
• Oil bottle
• Adaptor
• Comb lock switch (located on back of
clipper)
GETTING STARTED
CHARGING YOUR HAIRCLIPPER
•
Before using your hair clipper for the first time, charge for 14-16 hours.
•
Ensure the product is switched off.
•
Connect the charging adaptor to the product and then to the mains.
•
The charging indicator will illuminate. The indicator will remain illuminated when
the clipper is fully charged.
•
Your hair clipper cannot be overcharged. However, if the product is not going to be
used for an extended period of time (2-3 months), unplug it from the mains and
store. Fully recharge your hair clipper when you would like to use it again.
•
To preserve the life of your batteries, let them run out every 6 months then recharge
for 14-16 hours.
INSTRUCTIONS FOR USE
BEFORE STARTING THE CUT
•
Inspect the clipper making sure it is free from hair and dirt.
•
Seat the person so that their head is approximately at your eye level.
•
Before cutting, always comb the hair so it is tangle free and dry.
TO ATTACH A COMB
•
Hold the clipper vertically.
•
Line the comb rails up with the vertical channels on the sides of the clipper and
slide the comb all the way until it stops.
•
NOTE: Please make sure that the comb locking mechanism is not activated (the
switch on the back of the clipper should be in the down position when attaching a
comb).
