6
TO REMOVE A COMB
•
Holding the clipper with the blades facing away from you, firmly push the comb
upward and away from the blades.
•
NOTE: Please make sure that the comb locking mechanism is deactivated (the
switch on the back of the clipper should be in the down position when removing
the comb).
ADJUSTING THE TRIM LENGTH
•
The comb attachment can be adjusted to give you 4 different trim lengths.
•
Move the comb up or down to the preferred setting and slide the switch on the
back of the product up to lock the comb. To unlock, slide the button down.
Comb Position
Short Comb
Long Comb
1
6mm
18mm
2
9mm
3
12mm
4
15mm
•
1mm length is achieved without any combs.
•
0.5mm is achieved without any combs and holding the blades perpendicular to the
skin.
INSTRUCTIONS FOR CUTTING HAIR
•
Note: for even cutting, allow the comb attachment/blade to cut its way through the
hair. Do not force it through quickly. If you are cutting for the first time, start with
the highest setting.
STEP 1 - NAPE OF THE NECK - DIAGRAM A
•
Use setting 1 (6mm).
•
Hold the clipper with the blade teeth pointing upwards. Begin starting at the centre
of the head at the base of the neck.
•
Slowly lift the clipper, working upwards and outwards through the hair, trimming
just a little at a time.
STEP 2 - BACK OF THE HEAD - DIAGRAM B
•
With setting 3 (12mm), cut the hair at the back of the head.
STEP 3 - SIDE OF THE HEAD - DIAGRAM C
•
With setting 1 (6mm), trim the sideburns. Then change to setting 2 (9mm) and
continue to cut to the top of the head.
