SPRACHE
4
4
SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS
Starting with the longest guide comb attached (25mm), cut from the back of the neck
to the crown. Hold the guide comb fl at against the head and slowly move the clipper
through the hair, as shown. (DIAGRAM 1)
Use the same procedure from the lower side to the upper side of the head, as illustrated.
Then cut the hair against the direction in which it grows and level with the sides.
(DIAGRAM
3)
To give a “fl at top” look, the hair on top of the head must be cut over the top of a fl at
comb.
Use a closer guide comb to taper the hair down to the neckline as desired.
CARE FOR YOUR HAIRCLIPPER
Your clipper is fi tted with high quality titanium blades. To ensure long lasting performance
of your clipper, clean the blades and unit regularly. Always keep the protective cap on the
trimmer blade and lubricate the clipper lightly before and after cleaning.
AFTER EACH USE
Note: This product is only washable if purchased in the United Kingdom and has a three-
pin charging adaptor. Due to European legislation we are unable to offer this feature in
Western and Eastern European countries.
Ensure the clipper is switched off and disconnected from the mains.
Brush or rinse the accumulated hair from the blades. Do not submerge the clipper in
water.
Place one or two drops of oil on the blades. Turn the clipper on to distribute the oil even-
ly, wipe off any excess oil. Excess oil will cause damage to your product.
To clean the unit, wipe with a damp cloth and dry immediately.
Note: Ensure that the clipper is turned off when cleaning or applying oil.
EVERY SIX MONTHS
At regular intervals the Blade Set should be removed and cleaned.
Remove the 2 screws retaining the fi xed blade with a screwdriver. Do not remove blade
set.
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
ENGLISH
