15
To Change Attachments
WARNING:
Always ensure the unit is OFF and the power cord is disconnected before
removing the attachments.
Allow the system to cool down for 5 minutes before attempting to change the Treatment Cap
1. Turn the Power Switch OFF and unplug the Power Cord from the electrical outlet.
2. Hold the device with one hand while gently pulling the Treatment Cap with the other (Fig 16).
NOTE:
Treatment Caps are magnetically held onto
the device and should pull off easily.
TIP:
Store the unused Treatment Cap in a safe
location taking care not to damage the flash
window and other components. Gently push the
other Treatment Cap back onto the device making
sure it clicks into place.
Multi-Flash Mode
The i-LIGHT® Smooth Sense device will flash when
the Flash Button is pressed and will continue to flash every 3 seconds when the skin contact
sensors are fully engaged. The Multi-Flash mode allows you to quickly treat large areas by
simply gliding the hand piece over the skin after each flash.
How To Treat
1. Place the Flash Window firmly against the skin - ensure the Skin Contact Sensors are fully
engaged. If the Skin Contact Sensors are in full contact, the flash button on the device will
pulse white and the LEDs on the side of the hand piece will light up indicating the device is
ready to flash, plus you will hear a ticking sound.
NOTE:
If the Skin Contact Sensors are NOT in full contact with the skin, the device will not
operate if you press the Flash Button and it will ‘beep’. Double check that the Skin Contact
Sensors are in full contact with the skin.
2. Press the Flash Button to deliver a flash. You should expect to see a bright flash of light
(similar to a camera flash) and you should feel a mild sensation of warmth.
3. Move to the next area and treat in a grid like pattern to ensure full coverage of the
treatment area.
• For single-flash mode, press the Flash Button each time you move to the next area.
Fig 16
