43
Troubleshooting
PROBLEM
POSSIBLE
CAUSE
WHAT YOU SHOULD DO
When I place the
REMINGTON iLIGHT
Face and Body
against my skin,
nothing happens.
The HAND PIECE
doesn’t beep, even
after a few sec-
onds.
The
REMINGTON
iLIGHT Face and
Body is locked.
Unlock the REMINGTON iLIGHT Face and
Body with the SKIN TONE SENSOR, based on
steps on page 26. Note that the REMINGTON
iLIGHT Face and Body must be unlocked
again if you don’t use it for 5 minutes. If you
take a break in the middle of a treatment, or
turn off the device, you will need to unlock
the REMINGTON iLIGHT Face and Body again
to use it. See steps on page 30 for “Test a
Patch of Skin” using the Skin tone sensor.
The CONTACT
SENSORS aren’t
in full contact with
the skin.
Check that both CONTACT SENSORS are
touching your skin. The REMINGTON iLIGHT
Face and Body won’t work unless it’s flat
against your skin. See steps 2b-2f on page
27 for this situation.
You are trying
to treat a small
area, such as
fingers or toes.
You can try pulling your skin to make a bigger
flat area, pushing part of your skin so that the
window can reach it (such as another finger)
next to the part you want to treat. If you can’t
get the entire window to touch your skin, the
REMINGTON iLIGHT Face and Body will not
work.
Summary of Contents for iLIGHT SP6000FUS
Page 6: ...6 Figure 1 iLIGHT Face and Body System Diagram Reference...
Page 54: ...54 Treatment Cards...
Page 55: ...55...
Page 56: ...56 Treatment Cards...
