44
Troubleshooting
PROBLEM
POSSIBLE
CAUSE
WHAT YOU SHOULD DO
A light flash
is not emit-
ted when
I press the
FLASH
BUTTON.
The CONTACT
SENSORS are
not in full con-
tact with the
skin.
Check that both CONTACT SENSORS are touching
your skin. The REMINGTON iLIGHT Face and Body
won’t work unless it’s flat against your skin. See
steps 2b-2f on page 27 for this situation.
You have not
waited enough
time between
flashes for the
REMINGTON
iLIGHT Face and
Body bulb to
recover.
The REMINGTON iLIGHT Face and Body requires
5 seconds to recover between flashes. When your
REMINGTON iLIGHT Face and Body device is ready
to flash (and assuming the CONTACT SENSORS are
flush against the skin), the device will emit three
“BEEPS” to confirm that it is ready to flash. See
steps 2b-2f on page 27 for this situation.
The LAMP
CARTRIDGE
has flashed
30,000 times
and needs to
be replaced.
You should
see the Light
Bulb flashing
YELLOW.
Make sure that the BULB LIFE LIGHT is either solid
green or solid yellow. If it is flashing yellow, disconnect
REMINGTON iLIGHT Face and Body and replace the LAMP
CARTRIDGE. Refer to “Replacing the LAMP CARTRIDGE”
on page 39.
Summary of Contents for iLIGHT SP6000FUS
Page 6: ...6 Figure 1 iLIGHT Face and Body System Diagram Reference...
Page 54: ...54 Treatment Cards...
Page 55: ...55...
Page 56: ...56 Treatment Cards...