5
F
INSTRUCTIONS FOR USE
,
TO ATTACH / REMOVE ATTACHMENT HEADS
1
Select attachment head that best fits your grooming needs.
2
Place attachment head on top of the unit. Secure carefully until the
attachment head clicks into place.
3
To remove attachment head press the head release buttons on the side of
the head and pull the attachment head away from the product unit.
4
Slide On/Off Switch upward to power the beard trimmer.
,
TO ATTACH / REMOVE A COMB
5
The Adjustable Comb attachment is to be used with the Wide Trimmer
Attachment Head. To add, align the Comb side rails with the slots of the
wide trimmer head. Secure the Comb by sliding downward. (NOTE: a
clicking sound means Comb attachment is secure and ready for use).
6
To use one of the 4 attachment guide combs, hook the front edge of the
comb to the front teeth of the wide trimmer blade. Then push the back of
the comb down until it snaps in place.
,
NOTE: The Adjustable Comb has various length settings. When first
becoming familiar with the beard and grooming kit, begin with a higher
numbered setting. Adjust cutting length, as desired.
,
INSTRUCTIONS FOR BEARD TRIMMING
,
Note: For even cutting, allow the comb attachment/blade to cut its way
through the beard hair. Do not force it through quickly. If you are cutting for
the first time, start with the maximum comb length attachment
,
TO THIN AND TAPER THE BEARD/MOUSTACHE
7
Turn the unit on.
8
Select the desired length fixed comb or length setting on the adjustable
comb. Place the flat top of the trimmer comb against the skin.
9
Slowly slide the through the hair. Repeat from different directions as
necessary.
10 If hair builds up in the trimmer comb during the trimming process, switch
the unit off, pull off the comb and brush off. If hair builds up in the trimmer
comb during the trimming process, switch the unit off, pull off the comb and
brush the hair off.
11 Regularly check the level of collected hair in the vacuum chamber. Once this
becomes full, switch off the beard trimmer and then remove the vacuum
chamber to empty the hair clippings. To continue using, slot the vacuum
chamber back into product and then slide on the power switch.
