2
3
4
6
5
Product Features
SHAVER PARTS
1.
Pivoting head & cutter assembly
2.
Head release button
3.
Individual flexing heads
4.
On/Off push button
5.
Power port
6.
Trimmer button
7.
Head guard
6
7
9
8
8.
Power cord
9.
Cleaning brush
2
4
5
1
3
Pivot & Flex Technology
Power System
Cord/Cordless
– shaver can be used with or without the power cord.
Quick Charge
Shaver will charge long enough for one shave in 5 minutes.
Indicators
Fuel Gauge
– displays the amount of battery remaining, including low battery.
About Your Shaver
Voltage Type
Worldwide Voltage
– shaver automatically adapts to an outlet voltage between
100V and 240V.
Fuel Gauge
FEATURE
R5150AU
POWER SYSTEM
cord/ cordless
FULL CHARGE TIME
90 min
CORDLESS SHAVE TIME
30 min
QUICK CHARGE
yes
INDICATORS
fuel gauge
VOLTAGE TYPE
worldwide
REPLACEMENT PART NO.
SP-5161AH
Adjusting To Your Shaver
Removing The Protective Head Guard
As with every shaver, your shave will improve over time. Allow up to four weeks
of daily shaving to develop an effective shaving style and for your skin to adjust
to the new shaver. The adaptation period may take a little longer if your skin
is sensitive, if you are switching from a different method of shaving, or if you
alternate between shaving methods.
Before operating your shaver, remove the protective head guard, which protects
the head and cutter assembly. It is important to remove it correctly to avoid
damaging the clips that hold it to the shaver.
1.
Press lightly on the top of the protective head guard.
2.
Lift the lower rear edge.
3.
Pull the protective head guard away from the shaver. When the shaver is not in
use, always keep the protective head guard on the shaver head and keep the
trimmer in the OFF position.
Charging
Before using, read the important safety instructions in front of the manual.
1.
Plug power adaptor into shaver. (Diagram A)
2.
Plug power adaptor into wall outlet. (Diagram B)
3.
Charge shaver for duration specified on page 3.
Note:
During initial charge
ignore the electronic indicators as they are in "start up cycle".
4.
Use shaver until recharge is required. To preserve the life of the batteries, allow
the shaver to fully discharge every six months, and then recharge the shaver for
a full 24hrs.
CAUTION!
■
Make sure the shaver and your hands are dry when charging the shaver.
■
Always charge the shaver in a cool, dry place.
A
B
Shaving
Before using, read the important safety instructions in this manual.
1.
Press the On/Off button to activate for shaving (Diagram C).
2.
Hold the shaver so that all the heads touch your face together (Diagram D).
This allows the shaver to work the way it was designed for the closest shave
and minimum wear. Avoid holding the shaver at an angle so that only one head
touches the skin.
Use short, circular stokes. Use your free hand to stretch your skin. This
encourages your whiskers to stand out, making it easier for them to enter
the cutting chamber.
Never press hard when shaving. Pressing hard only flattens the whiskers,
which makes it harder for them to enter the cutting chamber. It will also
cause the cutting surface to wear out more quickly.
3.
Press the On/Off button to turn the shaver off (Diagram C).
A
B
C
D
■
Ensure your skin is dry and free of skin oils.
■
Wait at least 15 minutes after getting up before shaving, to ensure your face
is free of puffiness that may be present from sleeping.
■
Always hold the shaver at a right angle to the skin so that all three heads are
touching the skin with equal pressure.
■
Stretch skin with the free hand so hairs stand upright, making it easier for
them to enter the cutting chamber.
■
Use moderate to slow, circular stroking movement.
■
The use of short, circular motions in stubborn areas may obtain a closer shave,
especially along the neck and chin line.
■
Do not press hard against the skin to avoid skin irritation and/or damage to
the rotary heads.
**Remington recommends that you use your new shaver daily for up to four weeks to
allow time for your hair and skin to become accustomed to the new shaving system**
Shaving Tips
Trim
E
F
G
To use the pop-up trimmer, hold the shaver as shown in Diagram E, and simply
pull the trimmer release button down to engage the trimmer. The trimmer will
pop up, ready for use. To conserve battery power, it is recommended to use the
trimmer only when needed for trimming. When you have finished trimming, push
the trimmer downward to lock it into the off position (Diagram G).
To Trim Sideburns
Simply touch the edge of the trimmer to the desired line for neat clean sideburns
(Diagram F).
To Trim Moustache
Hold the shaver at the desired trim line for a quick, easy and professional trim.
The trimmer can also be used to trim the upper edge of your moustache.
The shaver is a washable appliance. The head
assembly part may be cleaned under warm water.
Cleaning & Care
NOTE:
**When cleaning your shaver, make sure the shaver is turned off
and disconnected from the power cord.**
CAUTION!
■
To clean the external surfaces of the shaver, use a damp cloth. Do not use strong
detergents or other chemicals.
■
To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer
or heater to dry the shaver.
■
The shaver should not be used until it has dried.
■
Do not remove or replace the head assembly while the shaver is running or
plugged into an electrical outlet, as it may cause damage to the shaver’s cutters.
