REMKO ELT 40, Assembly And Operating Instructions Manual

1.6  Safety instructions for the oper-

ator

The operational safety of the units and compo-

nents is only assured providing they are used as

intended and in a fully assembled state.

n

The personnel tasked with operating the units

must check the units for visible defects on the

operating and safety devices as well as the

presence and function of the protective devices

prior to starting work.

If defects are discovered these must be

reported to the supervisor!

n

In the event of defects that endanger the

operational safety of the unit, operation must

be discontinued immediately.

n

Do not operate units or components with

obvious defects or signs of damage.

n

Observe the respective local regulations and

the relevant electrical safety measures when

using the units.

n

Safety devices must not be bypassed or disa-

bled.

n

Maintain safety distances to combustible mate-

rials.

n

Never insert foreign objects into the units.

n

The units must not be covered during opera-

tion.

n

The units must not be operated in the vicinity of

bathtubs, showers, swimming pools etc.

n

The units must not be operated directly below

a wall socket.

n

The units and components must not be

exposed to any mechanical load, extreme

levels of humidity or extreme temperatures.

n

Never allow water to enter the units.

n

Protective covers (grilles) over moving parts

must not be removed from units that are in

operation.

n

Contact with equipment parts or components

can lead to burns or injury.

n

All housing parts and unit openings, e.g. air

inlets and outlets, must be free from foreign

objects.

n

The air outlet must not be constricted or

equipped with pipe or hose lines.

n

All electrical cables for the units must be pro-

tected against damage, including damage

caused by animals.

n

The units must be inspected by a service tech-

nician to ensure that they are safe to use and

fully functional at least once yearly. Visual

inspections and cleaning may be performed by

the operator when the units are disconnected

from the mains.

1.7  Safety notes for installation,

maintenance and

inspection work

n

The units and components may only be set up,

installed and maintained by qualified per-

sonnel.

n

Appropriate hazard prevention measures must

be taken to prevent risks to people when per-

forming installation, repair, maintenance or

cleaning work on the units.

n

The setup, connection and operation of the

units and its components must be undertaken

in accordance with the usage and operating

conditions stipulated in this manual and comply

with all applicable regional regulations.

n

Regional regulations and laws must be

observed.

n

The units must be installed and operated in

such a way that personnel are not endangered

by warm air and radiant heat and that no fires

can occur

n

A safety zone of 1.5 m should be maintained

around the units - including non-combustible

items

n

The power supply should be adapted to the

requirements of the units.

n

Mobile units must be set up securely on suit-

able non-combustible surfaces.

n

The units and components should not be oper-

ated in areas where there is an increased risk

of damage. Observe the minimum clearances.

n

The units and components must be kept at an

adequate distance from flammable, explosive,

combustible, abrasive and dirty areas.

n

The units must not be installed or operated in

atmospheres containing oil, sulphur or salt.

n

The units must not be exposed to direct jets of

water, e.g. pressure washers etc.

n

Safety devices must not be bypassed or disa-

bled.

1.8  Unauthorised modification

and changes

Modifications or changes to units and components

are not permitted and may cause malfunctions.

Safety devices may not be modified or bypassed.

Original replacement parts and accessories

authorised by the manufactured ensure safety. The

use of other parts may invalidate liability for

resulting consequences.

5