System configuration
Operation
The system can be easily operated
via the fully automatic controller
μC2SE. If due to local conditions
programming via the internal con-
trol course difficulties, the system
can also be programmed via a ca-
bled remote controller (accessory)
or an external ON/OFF-Switch.
If a combination of letters /
numbers is shown in the dis-
play, then there is a malfunc-
tion in the unit (see chapter on
trouble-shooting and customer
service).
!
CAUTION
The system is designed as a two
pipe system.
The system has 2 medium pipes
(supply and return) for cooling
using a cold medium or heating
using a warm medium.
The medium can be circulated
to the room to be cooled via the
floor, or via the ceiling depending
on where the unit is mounted.
For each of the different systems, a
minimum flow volume and a mini-
mum medium volume is needed
for safe operation.
Chilled water system
System configuration
Medium intake
Medium outlet
Indoor area 1
Outdoor area
Indoor area 2
Indoor area 3
Room temperature control Room temperature control
Infrared remote control
Chilled water
appliance
Chilled water
appliance
Chilled water
appliance
Condensate drain
Condensate line (only
units with HP-function)
Condensate drain
Condensate drain
Condensate collecting drain
A centralised fault contact, part of
the standard equipment, can be
used for the external signalling of
a fault.
Methods of operation
Centralised
fault signal
Cable
remote control
Enable contact
On/OFF Cooling/Heating
(e.g. building management
system)
(Standard equipment)
(Standard equipment)
(Accessories)
Controller μC
2
SE
(Standard equipment)
7
Summary of Contents for RVS 100H INOX
Page 2: ......
