REMKO SLN 45, Operating And Installation Instructions

■

  Observe the regular care and 

maintenance intervals

■

   In accordance with 

the operating conditions, 
the units must be checked as 
and when required, but at least 
once per year, by a specialist 
to ensure that they are in 
a condition that is safe to use

■

   Keep the units free of dust and 

other debris

■

   If the unit is contaminated, 

it can be cleaned using 
a vacuum cleaner. The 
condensor in particular must 
be vacuumed thoroughly

■

   If the evaporator’s fins are 

heavily soiled, they can be 
cleaned carefully with soapy 
water

■

   Never subject to direct jets 

of water 

e.g. pressure washers 

etc.

■

   Never use abrasive or solvent-

based cleaners

■

   Use only suitable cleaners, even 

for heavy contamination

Care and maintenance

All moving parts have a low-
maintenance permanent coat 
of lubricant. The refrigerant system 
is designed as a hermetically sealed 
system and may only be repaired 
by a specialist. 

NOTE

Regular care and maintenance 
is fundamental to a long 
service life and fault-free 
operation of the unit.

Cleaning the suction filter

Check the suction filter at regular 
intervals and clean if necessary.  
The filter is secured in a bracket 
behind the intake openings. 

■

  Light filter contamination can be 

remedied with careful blowing 
or suction 

■

  Heavier contamination may 

be remedied by rinsing the filter 
in a lukewarm (max. 40 °C) 
soap solution Finally, always 
rinse the filter carefully with 
clear water and allow to dry

■

  Before refitting the filter, ensure 

that its fully dry and that no 
damage has been sustained 

■

  The units may only be operated 

with the filter in place 

Cleaning the condensate 
water collection tray

To ensure that the condensate 
water that accumulates can always 
drain freely, the collection tray for 
the condensate and the drain must 
be cleaned regularly.

NOTE

Heavily contaminated filters 
must be replaced with new 
parts.
Only original replacement 
parts may be used.

CAUTION

Check the intake and outlet 
openings, as well as filters, 
regularly for contamination.

Operating LED

The multi-colour LED display 
is located at the upper edge 
in the centre of the unit. They 
indicate the current operating 
state of the unit.

Legend of the LED colours

The LED lights up “blue” and 
stays that way when the unit is 
connected to the mains power 
supply. 
 
The LED lights up “green” 
and stays that way when 
the compressor is in operation 
and the unit is in dehumidifying 
ordefrosting mode.

The LED lights up “yellow” 
and stays that way when the unitis 
operating in wireless remotecontrol 
mode.

The LED lights up “red” when 
a fault has occurred. Please refer 
to the Troubleshooting chapter 
torectify the fault.

19