Fig. 18
14.
To install the baffle plate, guide it into the
opening (groove) provided. When installing
each additional ring element, the baffle plate
for the air outlet must always be installed
through the opening.
Fig. 19
15.
The baffle plate for the air outlet must rest
with the side of the foam insulation directly
on the outdoor unit.
Fig. 20
16.
After it has been installed, as shown in
Fig. 21, the baffle plate is horizontal in the
noise protection hood, directly in front of and
tight to the outdoor unit.
The aluminium frame must now be con-
nected to the base using suitable attachment
materials. If a concrete foundation/strip foun-
dation or flagstones are used, you must use
corresponding screws and anchor bolts. If
the noise protection hood is to be installed on
ground that has been prepared for it, use
suitable ground anchors. If the hood is not
attached, it is not secured against wind loads
and operation of the entire system is not per-
mitted. If the wind load is expected to be
higher than normal, REMKO recommends
securing the hood with additional storm
ropes.
Fig. 21
23
