12
REMKO VRS-C Series
Application examples:
REMKO ASD exhaust system
Stainless steel, double-walled,
outdoor mounting
REMKO ASE exhaust system
Stainless steel, single-walled,
indoor mounting
The exhaust gas system
components are connected very
simply through mating, and are
secured with clamps.
All REMKO stainless steel
exhaust systems are generally
approved by the institute for
construction technology [Institut
für Bautechnik].
Example of upright unit installation
7
8 / 9
1
2
3
4
5
6
We reserve the right to modify the dimensions and design as part of the ongoing technical development process.
500
Condensate drainage
Correct implementation of the
condensate trap is particularly
important, a poorly designed trap
impairs proper functioning of the
unit.
The following points should be
observed:
■
Danger of accumulation of
the condensate in the heat
exchanger;
■
Danger of freezing of the
condensate in the pipes;
■
Danger of exhaust gas
discharge via the condensate drain.
Condensate accumulation in the
heat exchanger
When installing the hot air
generator, make sure that the
surface is perfectly level, so that
the characteristic inclination of the
tube bundle is not affected.
Connection of condensate
discharge pipe
The VRS-C heating units are
delivered with condensate
drainage at the side of the unit.
Depending on the installation type,
the condensate drainage can take
one of the following forms:
■
as free discharge;
■
as discharge into rain gutters;
NOTE
Disconnect the cap of the
condensate drain before com-
missioning to allow regular
operation.
