How to install and disassemble
1. Take off the adhesive tape from latch.
2. Push and attach latch to door pillar. At this stage there is no need to
detach adhesive tape from the body.
3. Now please detach adhesive tape from the body.
4. Fix the body on the position where you want to install it
5. Remove assistant bushing after dismantling combination.
6. Press the adhesive tape to remove the air, so that the adhesive
strength between the body and latch will be increased.
* Test the lock using the remote controls
Please try to operate remote controls and check if the
installation was made properly.
* Please do not touch the
installed lock for 24 hours for
better adhesion.
* You can detach it easily from the door and carry it when you move to new place.
* Please purchase new latch and base plate with attached adhesive tape at our
distributor shop.
1. Please detach bolts on both sides of base plate from the body by using a cross driver (+).
2. Please cut the base plate attached to door while putting piano string or guitar string
between base plate and door surface and then pulling the string slowly.
Please note that if you stop it will not move again.(same method for latch)
3. It is easier to detach adhesive tape which is attached to the door after warming it by hair dryer.
