User instruction
Open the battery cover by pushing it to the direction (▼)and then insert two
AA alkaline batteries (refer to page 6)
Close the battery cover.
Once the lock is installed, please ensure that the remote control
works properly by testing it outside the door. You have someone
who can monitor the function inside during the test.
(After that, you two switch the position and test it again)
Transmission Distance of the remote control
Best place for transmission and reception of radio wave.
Antenna Angle (90¡ with lock body is the best, but may be different according to
circumstance.)
Alarm tone will ring from the lock when the door is "locked or open."
Locking and opening signals
▶ Push lock button→ "Pi~ik" (two-syllable rhythms) →the door is locked.
▶ Press open button →"Pik, pik, pik" (repeated single-syllable rhythm) →the
door is open.
▶ If the remote control does not work, please press the button again.
▶ Although it is possible to acknowledge the locking and opening of the door
by signals, you are recommended to confirm it yourself.
▶
▶
▶
▶
Function of informing the timing to change batteries.
▶ When LED light flickers every 4 seconds and signals sound like cricket, the
batteries must be changed immediately.
▶ If you fail to change batteries in time, the lock would stop functioning
(In this case, our company does not take any responsibility for the damage
caused by the discontinued function of the door lock.)
Hand lever.
The hand lever is designed to open easy in emergency such as fire.
Please remember!
4 pieces of remote control
are basically registered
Please register the codes
of these remote controls
again to ensure safety.
Please make sure that you
have to register the code
in the lock when you
purchase an additional
remote control.
(refer to page 8).