Normal Procedures 7 - 4
Rev. 01 – 07-01-2008
7 Normal
Procedures
If the engine does not start, release the key to position "0", wait 2 minutes and repeat
the procedure.
5.
Release ignition key, immediately after the engine has started
6.
Push the choke lever forward
7.
Switch of the electric fuel pump (if fitted)
Starting a hot engine:
1. Pull the throttle lever back to idle position
2. Turn the key clockwise to the “Start“ position and hold until the engine has started. Do not hold
the key in that position for more than 10 seconds, in order to avoid overheating the starter.
3. Release ignition key, immediately after the engine has started
After starting the engine:
1. Check oil pressure immediately after the engine has started
2. Adjust engine rpm as required - for warm up
maximum 2,500 rpm
3. Before take-off, oil and CHT temperature must reach
120°F
at least
4. Switch on avionics master switch and all required avionics devices
Engine rpm and propeller check:
1. Set parking brake
2. Adjust engine to 4,000 rpm
3. Check both magnetos – maximum rpm decrease 300 rpm
4. Set engine to idle
Summary of Contents for G 2008 Series
Page 1: ...i...
Page 7: ...vii Rev 01 07 01 2008 Views The REMOS GX is designed as full composite carbon fiber aircraft...
Page 15: ...Airplane and Systems Description 2 5 Rev 01 07 01 2008 2 Airplane and Systems Description...
Page 47: ...Performance 5 5 Rev 01 07 01 2008 5 Performance 5 5 Pressure Altitude Diagramm...
