- 3 -
USING THE # EVO-SIMPLEX T
x’s WITH A “CENTRE OFF” ESC.
The
# EVO SIMPLEX
Tx handpieces should only be used with
CENTRE OFF
ESC’s such as the
COBRA-260.
Before you switch the system on, make sure the knob is in neutral. i.e. at the centre “click”.
NEUTRAL OFF POSITION OF THE
# EVO-SIMPLEX
Tx’s.
SET THE FORWARDS DIRECTION
& INCREASE SPEED CONTROL.
SET THE REVERSE DIRECTION
& INCREASE SPEED CONTROL.
CENTRE OFF CONTROL.
FORWARDS -
SPEEDING UP.
To select forwards direction, twist the knob from neutral slowly clockwise (CW) to the right.
SLOWING DOWN
. Turn the knob back to the left (CCW) to set desired speed.
STOPPING
.
Completely stop the loco by bringing the knob back to neutral.
Once stopped wait one second before changing direction.
REVERSE -
SPEEDING UP.
To select reverse direction, twist the knob slowly to the left (CCW).
SLOWING DOWN
. Turn the knob back to the right (CW) to set desired speed.
STOPPING.
Completely stop the loco by bringing the knob back to neutral.
SHUTTING DOWN.
When you have finished operating, turn off the loco(s) before the TX.
# EVO-SIMPLEX. Directional Constant brightness lighting
.
Our 100 Watt
# COBRA-260
ESC’s have directional constant lights that suits bulbs as well as LED’s.
If the
# EVO-SIMPLEX
is being used with other ESC’s that do not have lighting outputs, use a
# Rx107-xx Rx
or our plug
in, in-Line lighting module
# MRW-SSLS
.
# EVO-SIMPLEX Sound Trigger.
The
# MRW-SSSS
is available for use with Ch # 5. See page # 1.
# EVO- Sound Triggers.
The
# MRW-SSTS
is available for use with Ch
’s # 2, # 4 & # 5. See below.
If the loco runs backwards, we reverse the motor wiring to correct the direction and maintain the standard.
If the directional lights are incorrect, swap over the wiring to them so they match the loco speed and direction.
Cruise Control.
Depending on the Rx it is quite OK to turn the TX handpiece OFF and allow the loco to continue cruising
at the set speed until the Tx handpiece is turned on again.
Be aware that when turning the Tx handpiece back ON, relinking can take a few seconds.