Remote Control Systems TX-5v2, Instructions Manual

- 5 - 

4. USING THE TX-5v2 WITH A “CENTRE OFF” ESC. 

The TX-5v2 is ideal for use with RCS 

CENTRE OFF

 ESC’s such as the # VIPER-10-15 & # VIPER-10-24.  

Before you switch the system on, make sure the large throttle knob is in neutral.  i.e. at the centre “click”. 
For only one loco, the direction knob will not be used.  It could be used for another Centre OFF ESC on Ch #3. 

CENTRE OFF CONTROL.   

FORWARDS - 

SPEEDING UP. 

To select forwards direction twist the large knob from neutral slowly clockwise (CW) to the right.   

SLOWING DOWN

.  Turn the large knob back to the left (CCW) to set desired speed.   

STOPPING

.

  Completely stop the loco by bringing the large knob back to neutral.   

REVERSE - 

SPEEDING UP.

To select reverse direction twist the large knob slowly to the left (CCW).  

SLOWING DOWN

.  Turn the large knob back to the right (CW) to set desired speed.   

STOPPING.

.

  Completely stop the loco by bringing the large knob back to neutral.   

SHUTTING DOWN.  

When you have finished operating, turn off the loco(s) before the TX-5v2.  

NEUTRAL. 

TRAVEL IN FORWARDS. 

TRAVEL IN REVERSE.

TROUBLESHOOTING. 

The TX-5v2 battery will eventually go flat if left switched on.  The TX-5V2 operating program will likely be disrupted. 
The Ch # 1 centering on the TX-5v2 system will need to be reset; 
1.)  Centre the Large Ch# 1 knob.  
2.)  Turn the TX-5v2 ON. The TX-5v2 ON– OFF light will come ON. 
3.)  Within 60 seconds, press and hold the bind button for 20 seconds. 
4.)  The TX-5v2 ON - OFF light will go off. 
Centre reset is complete.