7
Setup and Operations
Before using the ZRC-90, please install the batteries:
•
2xAAA (alkaline is recommended) batteries are required for
operation.
•
Remove the battery cover on the back of your remote.
•
Check the polarity of the batteries and the "+/-" marks inside the
battery compartment.
•
Insert the batteries.
•
Push the battery cover back in place.
L
CAUTION (battery safety)
−
Use new batteries of the recommended type and size only.
−
Never mix used and new batteries together.
−
To avoid chemical leaks, remove batteries from the remote
controller if you do not intend to use the remote for an
extended period of time.
−
Dispose of used batteries properly; do not burn or bury them.
(Please carefully read through the following sections of this user
manual and store for future reference.)
ZRC-90 can be included and operated in any Z-Wave network with
other Z-Wave certified devices from other manufacturers and/or
other applications. All non-battery operated devices within the
network will act as repeaters regardless of vendor to increase
reliability of the network.
ZRC-90 can act as a
secondary Central Scene Controller
and trigger
the pre-defined scenes through the gateway. Please follow “Add ZRC-
90 into gateway network” by the procedures of “Learn mode” and
“Scene activation and deactivation”.
Z-Wave Learn mode
ZRC-90 can also receive network information from other controllers
by enter “Learn mode”.
(Add / Remove ZRC-90 into / from gateway network)
Step
Setup Key
Setup LED Indication
on ZRC-90
1
Refer to your primary controller
instructions to process the Inclusion
/ Exclusion setup procedure.
-
