1
2
NU737_3_G2-FRA.qxd 7/10/04 10:19 Page 2.10
CLIO-TRICORPS NU737-3
C:\Documentum\Checkout\NU737_3_T2-ENG.win 14/12/2004 11:32
- page 10
2.10
GEAR LEVER
HANDBRAKE
POWER STEERING
To select reverse gear
(vehicle stopped)
Move the lever to neutral, then lift
up ring 1 against the gear lever knob
to enable selection of reverse gear.
The reversing lights will light up as
soon as reverse gear is selected
(with ignition on).
To release:
Pull up the lever slightly, press
button 2 and then lower the lever to
the floor.
The red warning light on the
instrument panel will light up if
you are driving with an incorrectly
released handbrake.
Make
sure
that
the
handbrake is properly
released when driving,
otherwise
overheating
may occur.
To apply:
Pull upwards, ensure that the
vehicle cannot move.
Depending on the slope
and/or vehicle load, it
may be
necessary to
apply the brake by two
additional notches and select a
gear (1st or reverse) for vehicles
with
a
manual
gearbox
or
position
P
for vehicles with an
automatic gearbox.
Never leave the steering wheel on
full lock when the vehicle is parked
if you have power assisted steering
fitted as this may damage the pump.
Never switch off the
ignition when travelling
downhill,
and
avoid
doing
so
in
normal
driving (power steering and
brake servo will not function).