Applications Engineering
RTA-FOUSB-MON User’s Manual Rev 1.8
6 / 29
August 2003
4. Running KD30 Debugger
Please note the hardware setup and software controls discussed here uses the RTA-M16C62P-SKP
(RTA-M16C62P Board and ICD kit).
Before running the debugger, connect the target board to the ICD using the 10-pin flat ribbon cable.
Connect one end of the mini-USB cable to the ICD and the other end to the PC. If you are using a
Renesas SKP starter kit such as RTA-M16C62P-SKP, the ICD should be on bus-powered mode. If not,
select target-powered mode and supply power on the target board.
To run the KD30 debugger, double click on kd30.exe shortcut in your desktop. An initial window, similar to
one shown below, will be displayed.
Fig. 4.1 KD30 Debugger Initialization Screen
Select ‘USB’ option and click on ‘OK’ button. The KD30 screen should appear. Please see the KD30 Help
on how to use the debugger (Start > Programs > Renesas-Tools > KD30 V.3.20 Release 1B >KD30
Help).
To close KD30, click on ‘File’ menu and select ‘Exit’; or, click on the close button on the upper right corner
of the Window. Please do not unplug or detach the ICD from your PC without closing KD30 first.
Detaching the ICD while KD30 is still up may cause problems when you try to use KD30 again.
