R01UH0823EJ0100 Rev.1.00
Page 213 of 1823
Jul 31, 2019
RX23W Group
10. Clock Frequency Accuracy Measurement Circuit (CAC)
10.2.2
CAC Control Register 1 (CACR1)
Note:
Set the CACR1 register when the CACR0.CFME bit is 0.
CACREFE Bit (CACREF Pin Input Enable)
This bit specifies whether the CACREF pin input is enabled or disabled.
FMCS[2:0]Bits (Measurement Target Clock Select)
These bits select the measurement target clock whose frequency is to be measured.
TCSS[1:0] Bits (Timer Count Clock Source Select)
These bits select the count clock source for the clock frequency accuracy measurement circuit.
EDGES[1:0]Bits (Valid Edge Select)
These bits select the valid edge for the reference signal.
Address(es): 0008 B001h
b7
b6
b5
b4
b3
b2
b1
b0
EDGES[1:0]
TCSS[1:0]
FMCS[2:0]
CACRE
FE
Value after reset:
0
0
0
0
0
0
0
0
Bit
Symbol
Bit Name
Description
R/W
b0
CACREF Pin Input Enable
0: CACREF pin input is disabled.
1: CACREF pin input is enabled.
R/W
b3 to b1
Measurement Target Clock Select
b3 b1
0 0 0: Main clock
0 0 1: Sub-clock
0 1 0: HOCO clock
0 1 1: LOCO clock
1 0 0: IWDT-dedicated clock (IWDTCLK)
1 0 1: Peripheral module clock B (PCLKB)
Settings other than above are prohibited.
R/W
b5, b4
Timer Count Clock Source Select
b5 b4
0 0: No division
0 1: ×1/4 clock
1 0: ×1/8 clock
1 1: ×1/32 clock
R/W
b7, b6
Valid Edge Select
b7 b6
0 0: Rising edge
0 1: Falling edge
1 0: Both rising and falling edges
1 1: Setting prohibited
R/W
