Renfert
8 Controls
Easyclean MD
15 / 28
sweep
(2 segments)
This mode performs most cleaning tasks with an evenly distrib-
uted sound field (standard ultrasound mode).
pulse
(3 segments)
Removes stubborn dirt using pulsed sound field distribution.
dynamic
(4 segments)
Combines the ultrasound modes
sweep
and
pulse
to improve
the overall cleaning power.
8.2
Operating status symbols
The following symbols are shown on the display as soon as the unit enters the respective operating
status:
End of
cleaning
Ultrasonic cleaning has been completed in full.
Remaining
time
Ultrasonic cleaning is running; the remaining cleaning duration
is shown below the symbol.
Dry operation
The tank is empty, or the filling level is too low. Dry-run detec-
tion is available during active heating.
Setup
Setup
mode is activated; the unit parameters can be changed.
Heating
The ultrasonic bath is currently being heated.
Temperature-
controlled
start
Ultrasonic cleaning will start automatically as soon as the set
cleaning temperature has been reached.
Temperature
limit
(can be used in
Normal mode)
A temperature limit is defined as a maximum permissible clean-
ing temperature. A higher temperature cannot be set.
The symbol flashes when the temperature limit is reached or
exceeded.
..
Programme
The displayed cleaning programme is selected (programme
number 1–4). A total of 4 cleaning programmes can be selec-
ted.
8.3
Operating modes
Operating
mode
Brief description
Display
Switched off
The unit is being supplied with power and
is switched off.
Off
