You can then edit the displayed data, if you want.lnput the new value and then press the key
to replace the old value with the new one.
• Pressing the key instead of after changing a value on the display registers the value
you input as a new data item,and leaves the old value as it is.
• You can delete a data value displayed using and by pressing
. Deleting
a data value causes all values following it to be shifted up.
• Data values you register are normally stored in calculator memory. The message “Data Full”
appears and you will not be able to input any more data if there is no memory left for data
storage. lf this happens, press the key to display the screen shown below.
Press
to exit data input without regis ering the value you just input.
Press if you want to register the value you just input, without saving it in memory. lf you do
this, however, you will not be able to display or edit any of the data you have input.
• To delete data you have just input, press
.
Regression calculations
Use the
key to enter the REG Mode when you want to perform statistical calculations
using regression.
REG .......................................................................................................................
• Entering the REG Mode displays screens like the ones shown below.
• Press the number key ( , , or ) that corresponds to the type of regression you want
to use.
21