•
The lights get hot during use. Keep the product away from easily flammable
materials when in use.
• When setting up the product, make sure that the cable is not pinched,
kinked or damaged by sharp edges.
• Attention, LED light:
- Do not look directly into the LED light!
- Do not look into the beam directly or with optical instruments!
• Correct polarity must be observed while inserting the rechargeable
batteries.
• Rechargeable batteries should be removed from the device if it is not
used for a long period of time to avoid damage through leaking. In case of
skin contact, leaking or damaged rechargeable batteries can cause acid
burns. Use protective hand wear when handling damaged rechargeable
batteries.
• Rechargeable batteries must be kept out of reach of children. Do not leave
rechargeable batteries lying around, as there is risk, that children or pets
swallow them.
•
All rechargeable batteries should be replaced at the same time. Mixing old
and new rechargeable batteries in the device can lead to rechargeable
batteries leakage and device damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or
thrown into fire. Never recharge non-rechargeable batteries. There is a
risk of explosion!
• Use only one rechargeable batteries of the right size and recommended
type (see “Technical data”).
• Only insert a rechargeable batteries into the product. Never use a non-
rechargeable batteries. Otherwise there is a risk of fire and explosion!
• Consult a professional if you require assistance with product operation,
safety or connection.
•
Maintenance work, adjustments and repairs may be carried out only by a
professional or at a specialist workshop.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
Installation
When installing the solar module
, make sure it faces south
and does not get
covered or shaded by objects such as trees or buildings. Select a location
with good sunlight conditions in order for the solar module to charge the
rechargeable batteries during daylight. During winter the solar module must
be kept free from snow at all times.
The installation distances between the spotlights and the solar module are
limited due to the cables. When preparing a fixed installation, make sure
your mounting arrangement is within the maximum mounting distances.
When drilling installation holes into the wall or when tightening screws,
make sure not to damage any existing cables or pipes!
a)
Overview
• The spotlights and the solar module are equipped with ball joints. The ball joints
allow for the product to be aligned to any direction easily.
• The screw connection of the ball joint supports the attachment of a mounting foot
(fig. 2)
or ground spike
(fig. 1)
. Turn the screw connection counter clockwise to
loosen or clockwise to tighten. Use only little force when tightening in order not to
jam the thread.
•
The solar module can be fitted with the pole mount
(fig. 3)
in order to attach the
module to, for example, a pole, railing, table, etc.
b) Ground spike
• Loosen the ball joint screw connection and attach the ground spike.
• Select a suitable location with a soft surface.
A stony surface will damage the
ground spikes.
• Push the spotlight/solar module including the ground spike as far as it goes into the
surface
(fig. 1)
. Make sure the installation is stable.
c)
Installation on a flat surface or wall
• Loosen the ball joint connection and attach the mounting foot.
• The mounting foot can be secured using the two bore holes in the foot. Drill
respective holes into the surface/wall and insert the dowels.
• Use two screws to attach the mounting foot
(fig. 2, fig. 4)
.
• Besides screw-type mounting there is the possibility to use the double-sided
adhesive slips for installation. The adhesive slips can be attached to the mounting
feet/mounting surface directly.
Caution!
Adhesive slips leave trace or damage surfaces. It is not suggested
to use adhesive slips on sensitive surfaces.
Operating instructions
Solar spotlight
Item no. 807610
Intended use
This product is intended for illuminating garden, balcony and patio areas.
The solar spotlight automatically turns on at nightfall and turns off at dawn. A fully
charged rechargeable battery pack can provide for an illumination period of approx. 8
hours. The solar module charges the rechargeable battery pack during daylight.
The product is suitable for outdoor use. The spotlights can be installed in the ground
using the supplied ground spikes or be mounted to a wall or flat surface using the
mounting feet.
For safety and approval purposes (CE), you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All
company names and product names are trademarks of their respective owners. All
rights reserved.
Delivery content
• Solar module
• 3 x spotlight
• 3 x mounting foot
• 3 x adhesive slip
• 4 x ground spike
• 8 x dowel
• 8 x screw
• Bracket holder
• Bracket
• Clamping jaw
• Wing nut
• Safety cap
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this operating instructions, we assume no liability
for any resulting personal injury or damage to property. Such cases will
invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may
become dangerous playing material for children.
•
Protect the product from extreme temperatures, strong jolts, flammable
gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a
low height can damage the product.
• Do not immerse the product in water.
• The product is only suitable for domestic use.
• The product is suitable for outdoor use.
