18
accessories
Our TX - TX / HD brakes can have, on customer request, some accessories that are not present in our standard
versions.
RPM COUNTER
One of the most used and requested accessories not present in our standard is the tachometer with its sensor. These
brakes will be supplied in the same composition as the standard brakes, except that a central disc (the last in the
assembly phase) will be replaced by a specially built central disc with one or more "notches" for the tachometer.
These discs, as for the standard versions, are also available in the High dissipation series version.
Disc standard with notches for RPM Disc HD with notches for RPM
• position the sensor at a distance of about one millimeter from the central disc, shaped with notches whose number
and shape depend on the type of PLC management.
• Then power up the sensor and check by turning the shaped central disc that the warning light on its upper end
flashes
Below is the list of our available tachometers. By default, Renova supplies on its brakes a tachometer with PNP
connection normally open (NO), but on request the PNP versions normally closed (NC) and the NPN versions both
normally closed and normally open are also available.
Type
Voltage
Current
Signal distance
Wiring
Renova Code
Standard
10 - 30 V CC
<200 mA
1,5mm
PNP (NO)
CG00000000
Customer request
10 - 30 V CC
<200 mA
1,5mm
NPN (NO)
CG00000NPN
Customer request
10 - 30 V CC
<200 mA
1,5mm
PNP (NC)
CG00000000-NC
Customer request
10 - 30 V CC
<200 mA
1,5mm
NPN (NC)
CG00000NPN-NC
Summary of Contents for Turborex TS 180
Page 33: ...33 ...
Page 34: ...34 NOTES ...
Page 35: ...35 Manual revision index Rev n Revision date Changes description ...
