56
Endura
®
Delta
en
Installer
8.2.1.2
•
Making the TouchDisplay the Sensor Controller
If you want to install an external TouchDisplay as an air quality sensor, you must make sure that a
Main Controller is installed that is connected to the Endura Delta using a cable.
When connecting the air quality sensor to the mains voltage, the screen for which the
TouchDisplay will be used as Sensor Controller appears.
Select “Main Controller” using the
▼
and
▲
buttons, and confirm your
selection by tapping
■
.
The/each TouchDisplay must be individually linked to the Endura Delta in
order to achieve wireless data transmission.
The “Link Sensor” screen appears and “Add Sensor” lights up.
It must now be linked to the Endura Delta.
Note:
A sensor can only be linked to a Main Controller! Therefore, a Main Controller must be
installed before you can link any sensors.
Procedure:
• The links must be done within close proximity. We recommend linking the Sensor Controller and
Main Controller within the same room at a distance of > 3 m.
• The link is made by individually “opening” an Endura Delta and a controller, and allowing
them to “search” for a connection.
• Ensure that the Main Controller is turned on (mains voltage must be live).
Then tap
■
in the TouchDisplay.
An extra line appears at the bottom of the display that says “Linking”.
Linking
Summary of Contents for Endura Delta 330
