62
Endura
®
Delta
en
Installer
The electric preheater is enabled by default if the Endura Delta is
equipped with an electric preheater. To turn off this function, briefly tap
■
.
To exit the menu, briefly tap
▲
and
▼
simultaneously.
Fire Place function
This menu shows you if the “Fireplace function” has been activated or not. The Fireplace function
can only be activated using an external switch that can be connected to the 24 V DC input
contact on the main board (see 7.1).
When turning on this function, the home is temporarily over-pressurised, so that the fireplace
burns easier and more oxygen is temporarily supplied.
Example: you set a differential flow rate of 50 m³/h. The unit operates balanced at a level of
200 m³/h supply and discharge. Upon activating the Fireplace function, the supply increases to
225 m³/h and the discharge decreases to 175 m³/h, so that the supply gains a difference of
50 m³/h.
Select “Fire Place function” using
■
.
Tap
■
to activate the function. The Fireplace function can only be
controlled via an external switch! (See Section 7.1 for the electrical
diagram.)
Select “Unbalance” using
■
and change the flow rate using
▲
and
▼
.
Confirm your choice by tapping
■
.
To exit the menu, briefly tap
▲
and
▼
simultaneously.
Summary of Contents for Endura Delta 330
